Maintenance Plan; Change Gearbox Oil; Storage; Disposal - Zipper Zi-Rbma1500 Betriebsanleitung

16.2.1

Maintenance plan

The type and degree of machine wear depends to a large extent on the operating conditions. The following
intervals apply when the machine is used within the technical limits:
Intervall
After usage
Weekly
Monthly
Half-yearly
Yearly
16.2.2

Change gearbox oil

16.3

Storage

Store the machine in a dry, frost-proof and lockable place when not in use. Make sure that unauthorised
persons and especially children do not have access to the machine.
Improper storage can damage and destroy important components. Only store packed or al-
ready unpacked parts under the intended ambient conditions!
16.4

Disposal

Observe the national waste disposal regulations. Never dispose of the machine, machine com-
ponents or operating equipment in the residual waste. If necessary, contact your local author-
ities for information regarding available disposal options.
If you purchase a new machine or equivalent equipment from your specialist dealer, he is
obliged in certain countries to dispose of your old machine properly.
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
Components
• Machine
Components that drive the
•
bending disc
• Bending tools (bending sleeve,
bending pin, counter pin, stir-
rup head)
Gearbox
•
• Screw connections
• Gearbox oil
Sealings, bearings
•
Machine components
•
Waste oils and fuel are toxic and must not be released into the environment!
Contact your local authorities for information on proper disposal.
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
•
•
•
•
•
•
•
•
•
•
N O TE
• Loosen the four screws (1) and remove the motor
cover (2).
• Loosen the oil drain plug (3).
• Drain the old oil into a suitable container.
• Reinstall the oil drain plug (3).
Loosen oil filler plug (4).
•
Fill in new gearbox oil (e.g. SAE80W-90, SAE140).
•
Reinstall the oil filler plug (4) and remove oil res-
•
idues with a cloth.
Fix the motor cover (2) again with the four
•
screws (1).
N O TE
Action
Clean
Clean and lubricate
Check for damages
Damaged bending tools must
not be used
Check for oil leckages
Check for firmness
Change gearbox oil
Check
Change if necessary
Replace skewed, cracked,
worn parts
ZI-RBMA1500
33