Safety Devices; General Safety Instructions; Electrical Safety - Zipper Zi-Rbma1500 Betriebsanleitung

12.3

Safety devices

The machine is equipped with the following safety devices:
12.4

General safety instructions

To avoid malfunctions, damage and health impairments when working with the machine, the following
points must be observed in addition to the general rules for safe working:
• Check the machine for completeness and function before starting. Only use the machine if the
separating and other non-separating protective devices required for machining have are fitted.
• Make sure that the guards are in good working order and properly maintained.
• Select a level, vibration-free surface as the installation area.
• Ensure sufficient space around the machine!
Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects.
•
Ensure a clean working environment.
•
Keep the area around the machine free of obstacles (e.g. workpiece parts, etc.).
•
Only use tools that are in perfect condition and free of cracks and other defects (e.g. defor-
•
mations).
Remove tool keys and other setting tools before switching on the machine.
•
Check the machine's connections for strength before each use.
•
Never leave the running machine unattended. Switch off the machine before leaving the work-
•
ing area and secure it against unintentional or unauthorized restarting.
The machine may only be operated, maintained or repaired by persons who are familiar and
•
who have been informed about the dangers arising from this work.
Ensure that unauthorized persons keep a safety distance from the machine and keep children
•
away from the machine.
Always work with care and the necessary caution and never use excessive force.
•
Do not overload the machine!
•
Hide long hair under hair protection.
•
Wear suitable protective equipment (eye protection)!
•
• Never wear loose jewellery, loose clothing or accessories (e.g. tie, scarf).
• Do not work on the machine if you are tired, not concentrated or under the influence of medi-
cation, alcohol or drugs!
• Shut down the machine and disconnect it from the power supply, before adjustment, change-
over, cleaning, maintenance or repair work, etc. Before starting work on the machine, wait until
all tools or machine parts have come to a complete standstill and secure the machine against
unintentional restart.
• Warning signs and/or stickers on the machine that are illegible or have been removed must be
replaced immediately!
12.5

Electrical safety

Make sure that the machine is grounded.
•
Only use suitable extension cables.
•
A damaged or tangled cable increases the risk of electric shock. Handle the cable with care.
•
Never use the cable to carry, pull or disconnect the power tool. Keep the cable away from heat,
oil, sharp edges or moving parts.
• Proper plugs and outlets reduce the risk of electric shock.
• Water entry into the machine increases the risk of electric shock. Do not expose the machine to
rain or moisture.
• The machine may only be used if the power supply is protected by a residual current circuit
breaker.
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
With the emergency stop switch dangerous movements can be stopped at any
time.
The motor protection switch (1) interrupts the power supply in case of an overvolt-
age in the power supply system.
SAFETY
24
ZI-RBMA1500