Handling; Switch The Machine On / Off; Control Panel; Rotation Direction Of The Bending Disc - Zipper Zi-Rbma1500 Betriebsanleitung

15.2

Handling

15.2.1

Switch the machine on / off

15.2.2

Control panel

1. P1 button
2. P2 button
3. P3 button
4. Emergency stop switch
5. Prog. On-OFF
6. MAN-AUTO button
7. Direction of rotation switch
15.2.3

Rotation direction of the bending disc

ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
Switch the machine on
Open the electric panel cover (2) with the nut spinner (1).
•
Set the motor protection switch (3) to position (I).
•
• Connect the machine to the mains supply.
Switch the machine off
Disconnect the machine from the mains supply.
•
• Open the electric panel cover (2) with the nut spinner (1).
• Set the motor protection switch (3) from position (I) to position
(0).
NOTE: In dangerous situations, press the emergency stop switch (1).
Adjustment for bent bar bending
Adjustment for set-square bending
Adjustment for hook bending
Stops the machine by interrupting the power supply in an emer-
gency.
For programming serial bending. A maximum of nine bending
angles can be entered.
Provides the choice between the manual and automatic opera-
tion of the machine.
Bending disc rotates clockwise = recommended direction
of rotation.
Bending disc rotates counter clockwise.
• To check the rotation direction, set the MAN-
AUTO switch on the control panel to the "MAN"
position and afterwards depress the foot pedal.
OPERATION
28
ZI-RBMA1500