Mechanical Mounting; Electrical Mounting - WIKA WUD 2 E-Serie Betriebsanleitung

4. Mounting
DC voltage
Do not dispose of with household waste. Ensure a proper disposal in accordance with national regula-
tions.
EN
4. Mounting

4.1 Mechanical mounting

Requirements for the mounting point
Only use the transducer if it is in perfect condition with respect to safety.
Prior to commissioning, the transducer must be subjected to a visual inspection.
Obvious damage must be reported immediately.
■
WARNING!
Damage to property due to improper welding
Improper welding can lead to a short-circuit and damage to electrical equipment.
▶
▶
▶
→ For information on tapped holes and welding sockets, see technical information IN 00.14 at www.wika.com

4.2 Electrical mounting

Pin assignment
→ For pin assignments, see product label
The pin assignment on the product label refers only to the M8 3-pin for power supply. For the pin assign-
ment of the RJ45, see data sheet PE 87.12.
6
Before arc-welding, ensure the transducer is not connected to any other devices.
Disconnect all electrical connections to the transducer.
Ensure that the supply lines from the stranded wire do not come into contact with metal surfaces.
WIKA operating instructions ultra high purity transducer, model WUD-2x-E