Setting/Adjusting Groove Diameter; Stabilizer Operation - RIDGID 918-I Bedienungsanleitung

Pipe Center
Line
°
1/2
Figure 12 – Offsetting the Pipe 1/2°, (Exaggerated)
8. Restrict access or set up guards or barriers to create
a minimum 3' (1m) clearance around the equipment
and pipe. This helps prevent non-operators from con-
tacting the equipment or pipe and reduces the risk of
tipping or entanglement.
9. With dry hands, plug the machine into a properly
grounded outlet.

Setting/Adjusting Groove Diameter

NOTICE Due to differing pipe characteristics, a test
groove should always be performed before the first groove
of the day or when changing pipe size, schedule, mate-
rial, or lot to reduce the risk of out of tolerance grooves.
Groove diameter must be measured to confirm proper
size.
1. Confirm that equipment is properly set up and pipe is
properly prepared and loaded. Improper set up and
preparation can affect accuracy of groove diameter
settings.
2. Groove roll should be lightly gripping the pipe. If
needed, advance the groove roll to just touch and
lightly grip the pipe – it should not be making an in-
dentation in the pipe, do not apply excessive pressure.
3. Rotate the depth adjustment nut until it stops against
main housing.
4. Back the depth adjustment nut off one turn (Figure
13).
999-998-676.10_REV. D
Pipe Direction
of Rotation
Drive Shaft
Center Line
Each Mark Approx.
Figure 13 – Depth Adjustment Nut Setting
5. Make a test groove.
6. Inspect/measure the test groove. If the groove di-
7 . Repeat steps 4-6 until the groove diameter is within

Stabilizer Operation

The stabilizer is used to apply slight force to 2
pipe to improve tracking. It is especially useful for short
pieces of pipe, but can be used on all lengths of pipe.
The stabilizer also reduces the swaying of longer, larger
diameter pipe.
1. Properly set up equipment and load pipe.
2. Set groove diameter.
3. Rotate the stabilizer crank handle to bring the roller
918-I Roll Groover
Increase Groove
Diameter
0.002"
(0.05mm)
ameter is not in specification, the depth adjustment
nut must be repositioned to give the correct groove
diameter. See Figure 13.
• To increase groove diameter (shallower groove), turn
the depth adjustment nut clockwise.
• To decrease groove diameter (deeper groove), turn
the depth adjustment nut counterclockwise.
• Each ¼ turn of the depth adjustment nut changes
the groove diameter approximately 0.025" (0.6 mm).
Moving the nut one mark on the circumference chan-
ges groove diameter approximately 0.002" (0.05 mm).
specifications. If the groove is too large, the groover
can be adjusted and the groove made smaller. If the
groove is too small, another groove will need to be
made. Proper groove diameter is important to ensure
connection performance. Out of specification grooves
could cause joint failure.
in contact with the pipe. Rotate the crank handle an
additional one (1) turn to preload the roller against
the pipe (Figure 14). Do not reach across the pipe to
adjust the stabilizer.
Decrease Groove
Diameter
/ " to 12"
1
2
11