EINHELL GP-CLM 47 S HW Li Originalbetriebsanleitung Seite 27

Insert the mulching blade only when the machine
has been switched off , the safety plug (12) has
been pulled out and the batteries (16) removed.
To use the mulching function, disconnect the
catch bag, slide the mulching adaptor (Fig. 5d/
Item 18) through the ejector opening and close
the ejector fl ap again.
Rear ejector (Fig. 14)
To use the rear ejector function you must open
the ejector fl ap (Fig. 14/Item 7) slightly. Lock it in
place with the locking lever. Swing up the locking
lever and insert its foot into the recess provided.
The mulching adapter (Item 18) is not allowed to
be fi tted when the rear ejector is used.
Side ejector (Fig. 15b)
You must fi t the mulching adapter (18) in order to
use the side ejector. Hook in the side ejector ad-
apter (19) as shown in Fig. 15b.
Charging the battery (Fig. 21)
The battery charger can be used to charge a
maximum of four rechargeable batteries. By char-
ging independently you can also charge diff erent
batteries (e.g.: 2.0 Ah; 4.0 Ah; 3.0 Ah and 5.2
Ah) for the charging times stated on the charger.
However, it is always the case that a maximum of
only two rechargeable batteries can be charged
simultaneously.
1. Pull the battery pack (16) out of the equip-
ment, pressing the pushlock button (b) to do
so.
2. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Insert the power plug of the charger
into the socket outlet. The green LEDs will
then begin to fl ash.
3. Insert the battery pack or packs (17) into the
battery charger (17).
4. In section 7 „Charger indicator" you will fi nd a
table with an explanation of the LED indicator
on the charger.
The battery pack can become a little warm during
the charging. This is normal.
If the battery pack fails to charge, check:
•
whether there is voltage at the socket outlet
•
whether there is good contact at the charging
contacts.
Anl_GP_CLM_47_S_HW_Li_SPK7.indb 27 Anl_GP_CLM_47_S_HW_Li_SPK7.indb 27
GB
If the battery pack still fails to charge, send
•
the charging unit
•
and the battery pack
to our customer service center.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
Installing the battery (Fig. 22)
Open the battery cover (Item 4). Then insert the
batteries in the mounts as shown in Fig. 22.
For optimum mowing results and battery power
performance it is always best to use batteries
with the same capacity of 3.0 Ah or higher. There
is also the option of using batteries with diff erent
capacities in the two battery mounts A and B (Fig.
2) which are opposite each other.
Always make sure, however, that you only use
batteries of the same capacity in each separate
battery bank (Fig. 27).
For example, you could use 2 x 4.0Ah batteries in
one battery bank while using 2 x 3.0Ah batteries
in the opposite battery bank.
Important!
Use only batteries which are charged to the same
level. Never combine full and half-full batteries. Al-
ways charge the two/all batteries simultaneously.
The equipment's operating time depends on the
battery with the lower charge level. The two/all
batteries must always be fully charged before use.
Close the battery cover by swinging it down, and
make sure that it latches in place correctly.
- 27 -
07.09.2022 13:06:33 07.09.2022 13:06:33