Cleaning And Maintenance - cecotec Rock'nCut Bedienungsanleitung

Using the food slicer
Plug the device into a power supply.
Place a plate or a dish near the slicer to collect the slices.
Move the platform away from the blade and lay the food to be sliced on the stainless-steel
surface of the carriage.
Push the food against the back plate with the pusher and select the slicing thickness - up to 15
mm - by turning the adjusting knob.
Turn the switch to the ON position. The blade will start rotating.
Push the platform using your thumb on the thumb guard to bring the food towards the blade.
Therefore, use the handle of the carriage and keep the pressure on the back plate of the
appliance using the pusher. Do not apply too much pressure, for best results. Fig. 2.
Note: If it becomes difficult to slice the food, move back a little bit and start the operation again
by approaching the blade slowly.
To avoid food from sticking to the appliance and to improve the slicing, moisten or oil the blade
with a towel beforehand.
Once slicing is done, switch the appliance off and wait until the blade comes to a
complete standstill. Place the thickness adjustment dial in the "0" position.

4. CLEANING AND MAINTENANCE

Always turn the appliance off and disconnect it from the power supply and set the plate at 0
mm before cleaning it.
Remove and clean any food rests after each use. Clean all the parts that come into contact
with food.
Use a soft cloth soaked in water to clean the appliance and then dry it.
Wipe the inside and housing of the appliance and the surface of the blade with a damp paper
towel or a soft cloth.
For a deeper cleaning, disassemble the food pusher, the sliding plate and the cutting disc in
order to clean them with warm water and kitchen detergent.
Dry all the product parts thoroughly before assembling them again.
Do not use abrasive cleaning agents or scouring pads to clean the appliance as these could
cause surface damage.
The pusher can be cleaned in warm soapy water. Rinse well after cleaning. Do not put in the
dishwasher.
Dry all parts well before storage.
Removing the sliding carriage for cleaning
Make sure the appliance is switched off and unplugged.
Set the thickness adjustment dial in the "O" position.
08021_Rock'nCut_Manual_YV_01200813.indd 31 08021_Rock'nCut_Manual_YV_01200813.indd 31
ENGLISH
31
ROCK´ NCUT
19/8/20 7:36 19/8/20 7:36