Electric Connections - Bpt TH124.01 Bedienungsanleitung

screws and screw anchors supplied (fig. 5, 6, 7).
WARNING. For the unit to work properly, we
L N
recommend you install it on a flat surface, being
careful not to overtighten screws.
C

ELECTRIC CONNECTIONS

Wiring will depend on the type of equipment con-
trolled by the thermostat: refer, therefore, to the
diagram in fig. 8 or fig. 9. Refit the terminal cover.
KEY
Mains power supply wires
L = phase LOAD
N = neutral
Relay contacts
U1
NA = normally open contact
C = common
Fig. 8
NC= normally closed contact
11