BWT BC02 Bedienungsanleitung Seite 2

GETTING STARTED
Charging the battery
IMPORTANT NOTE: Fully charge the electric vacuum for 6 hours before using it for the first time.
WARNING!
• Do not use the USB charging cable / USB charger if any damage is detected.
• Make sure both the electric vacuum and the charging port are clean and dry before charging them.
(TIPS : use a cotton bud to dry the charging port and charging pins)
• The charging pins are waterproof. However, remnants of water in the port and around the pins could result in
natural occurrence of stains (a byproduct of chemical reaction between water and electric currents). Otherwise,
the stains can be removed by light scrubbing with a cotton bud soaked with juice of lemon or vinegar.
1. Place the unit on a flat surface. Set the vacuum to
Power Off/ Charging position by turning the switching knob
anticlockwise until it stops and completely exposes the
charging port. Align and insert the USB charging cable into
the charging port.
2. Connect the USB charging cable to the USB charger, then plug the USB charger into the power source.
Once the electric vacuum begins to charge, the indicator light will turn red. Normally, it takes about 4.5 - 6 hours
to reach a full charge. The indicator light will turn green once the electric vacuum is almost fully charged.
NOTE
• Always disconnect the USB charger from the power source as soon as charging is complete.
• Immediately turn the power off and disconnect the USB charger from the power source if you detect any of the
following conditions: - Offensive or unusual odor
- Excessive heat
- Deformation, cracks, leaks
- Smoke
3. When charging is complete, disconnect the USB charger from the power source and unplug the USB cable
from the USB charger and electric vacuum.
Normally, the electric vacuum can operate up to 30 minutes on a full charge (after 4.5-6 hours of charging)
Note: Clean the filter regularly. Excessive debris inside the filter will increase burden to the motor operation and
shorten the operating duration as a result.
NOTE: Rechargeable lithium-ion battery is classified as a consumable item. It has a limited life and will gradually
lose its capacity to hold a charge. Therefore, the running time of the electric vacuum will gradually reduce after
repeated charging and discharging throughout its product life.
Once the lifespan of the battery reaches its end, refer to section "BATTERY DISPOSAL" for instructions regarding
battery disposal.
NOTE: Let the electric vacuum rest for 30 to 40 minutes before charging it again.
Pool Preparation
- If the liner is brittle, damaged, or wrinkled, contact a qualified professional to perform the necessary repairs or
perform a liner replacement prior to using the pool vacuum.
- If you are using a saltwater pool, make sure all salt are dissolved before placing the pool vacuum into the water.
OPERATION
Immerse the electric vacuum into water until water level reaches the switching knob.
Follow the direction of marking " I " to switch the knob clockwise until it comes to a
halt (you will hear a 'click" and a green dot will be exposed), the electric vacuum will
begin to work immediately.
CAUTION
• DO NOT cover the side slot (middle gap) of the electric vacuum during operation,
the impeller / motor may be damaged otherwise.
• Remove the electric vacuum from the pool/spa as soon as cleaning is complete.
CAUTION! Make sure the electric vacuum is always pointing downwards when it is placed into the pool. Otherwise, the pole connector
may be bent and damaged as a result.
To retrieve the electric vacuum from the pool / spa, lift the electric vacuum while pointing it downwards in order to allow water to discharge.
Rinse the electric vacuum with fresh water after every use. DO NOT use any detergent.
bwt.com
MAINTENANCE & CLEANING
EMPTYING THE FILTER
WARNING!
Using the electric vacuum without a filter bag / filter cage in place will VOID your warranty.
In order to maximize the cleaning efficiency of the cleaner, be sure to clean the filter bag/ filter cage before and after each use.
CAUTION! If the electric vacuum is charging, disconnect the USB charger from the power source and detach the electric vacuum
from the USB charging cable before making any attempts to clean it.
Emptying filter bag / filter cage
1. Place the electric vacuum on a stable surface.
2. Hold the electric vacuum body and turn the canopy anticlockwise until the
white marking on the canopy reaches the lock-unlock marking. (Fig.1)
Detach the canopy and remove the filter bag / filter cage from the electric vacuum
CAUTION! Replace a damaged filter bag / filter cage with a new one
before initiating the next operation.
3. Clean out the debris and rinse the filter bag / filter cage with water. If brushing is deemed necessary, use only a soft brush to clean
it gently and carefully.
4. Replace the filter bag / filter cage inside the electric vacuum. Reverse the steps to align and attach the canopy to electric vacuum
and turn the canopy anticlockwise until it comes to a halt.
CAUTION! Replace a damaged filter bag / filter cage with a new one before initiating the next operation.
MAINTENANCE & STORAGE
NOTE:
1.Be sure to clean and dry the areas around the charging port and charging pins after every use to avoid the forming of stains
(byproduct of a natural chemical reaction between electric current and water). Otherwise, the stains can be removed by light
scrubbing with a cotton bud soaked with juice of lemon or vinegar.
2.Battery discharges on its own during storage. The battery should be stored at room temperature, charged to about 30% to 50% of its capacity.
3.You must recharge the battery at least once every three months if it is not frequently used.
• Disconnect all USB charging peripherals.
• Detach all accessories from the electric vacuum. If necessary, rinse the electric vacuum and accessories with fresh water. DO NOT
use detergent.
• Be sure to drain the water from the electric vacuum before storing it.
• Use a damp cloth to clean and dry the electric vacuum and its accessories.
• Store them in a well-ventilated area away from the sunlight, children, heat, ignition sources, and pool chemicals. Ambient temperature
for storage should be 10˚C – 25˚C (50˚F – 77˚F). NOTE: A higher temperature may reduce the battery life during storage.
WARNING!
- Under no circumstances should you attempt to disassemble the electric vacuum and replace the impeller, motor and
battery by yourself.
CAUTION!
• Excessive heat can damage the battery and reduce the lifespan of your electric vacuum as a result.
• Consult your dealer regarding battery replacement if the following happens:
- Battery appears damaged or will not charge fully.
- Battery operation time is noticeably reduced. Observe and record the run times of the first few operations (on a full charge).
Use these run times as a reference point to compare with run times of older batteries.
• The battery must be removed from the electric vacuum before it is scrapped.
• The electric vacuum must be disconnected from the supply mains when the battery is being removed.
• The battery is to be disposed safely in accordance with local ordinances or regulations.
NOTE: Incorrect maintenance may reduce the battery life and affect its capacity as a result.
BATTERY DISPOSAL (To be carried out by authorized technician)
Your electric vacuum's battery is a maintenance-free, rechargeable lithium-ion battery pack, which must be disposed properly.
Recycling is required; please contact your local authorities for more information.
WARNING!
Never attempt to disassemble a battery pack
• Be sure to remove all personal items such as rings, bracelets, necklaces, and watches before you unwire the battery
pack from the electric vacuum.
• A battery can produce a short circuit current high enough to weld a ring (or similar items) to metal, potentially causing a
severe burn in the process.
• Wear complete eye protection, gloves, and protective clothing before you remove the battery pack.
• Avoid touching the wires altogether and avoid allowing them to make contact with any metal items, which could cause
sparking and / or short-circuit the battery.
• Never smoke or allow a spark or flame in the vicinity of the battery or the electric vacuum.
• Do not expose the battery to fire or intense heat as this may result in an explosion.
CAUTION!
If a battery leak occurs, avoid contact with the leaking fluids and place the damaged battery in a plastic bag.
- If leaking fluids come in contact with skin and clothing, wash immediately with plenty of soap and running water.
- If leaking fluids come in contact with eyes, immediately flush them with cool, running water for at least 15 minutes and do not rub
them. Seek medical attention immediately.
bwt.com
2021/10 : A 2/4 MAINTENANCE & CLEANING
Fig.1
2021/10 : A 3/4