Battery Charger - WARRIOR WEP8190CS Bedienungsanleitung

WARNING
Cutting edges on chain are sharp. Use protective
gloves when handling chain.
Keep chain sharp. Your saw will cut faster and more
safely. A dull chain will cause undue sprocket, guide bar,
chain, and motor wear. If you must force chain into wood
and cutting creates only sawdust with few large chips,
chain is dull.
Please contact customer service agent or approved
service agent for sharpening.

BATTERY CHARGER

SPECIFICATIONS
Charger: WEP8370BC
Input: 120-240VAC, 50/60Hz
Output: 42VDC. Max.2.2A
Weight: 1.2 lbs (0.55kg)
WARNING
The battery is not shipped/transported fully
charged. Fully charge the battery before first use
to ensure that maximum run time can be achieved.
This lithium-ion battery will not develop a memory
and may be charged at any time.
CHARGING PROCEDURE
LED STATUS
Blinking Green
Solid Green
Solid Red
Blinking Red (fast)
Blinking Red (slow)
Low voltage charging:
If the battery has been stored with little to no charge for
a long period of time, the charger will go into recovery
mode, which will take more time to fully charge the
battery. This will enhance the life of the battery. Once it
is fully charged, the next charge will return to standard
charging.
A fully discharged battery pack will require the allotted
time as stated in the battery manual. Plug the charger
into an AC power outlet.
Insert the battery -into the charger.
This is a diagnostic charger. The Charger LED Lights will
illuminate in specific order to communicate the current
battery status.
False defect note:
When the battery is inserted into the charger and the
status LED blinks RED, remove the battery from the
charger for 1 minute, then reinsert. If the status LED
blinks GREEN, then the battery is properly charging. If
the status LED is still blinking RED, remove the battery
and unplug the charger for 1 minute. After 1 minute,
plug in the charger and reinsert the battery. If the status
LED blinks GREEN, then the battery is properly charging.
If the status LED is still blinking RED, the battery is
defective and needs to be replaced
CHECKING THE CHARGE
If the battery pack does not charge properly:
Check the current at the power outlet with another tool.
Make sure that the outlet is not turned off.
Check that the charger contacts have not been shorted
by debris or foreign material.
If the air temperature is above 104°F or below
45°F, move the charger and battery pack to a room
temperature location and allow to warm up slowly.
DESCRIPTION
Charging
Fully charged
Stand by
Battery too hot
Charging fault
15
WARNING
If the battery is inserted into the charger when
warm or hot, the CHARGING LED indicator light
on the charger may switch on and illuminate RED.
If this occurs allow the battery to cool inside of
the charger for up to 30 minutes. Charging should
automatically start once battery has cooled
bATTERy CHARGER
EN