Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SAfETy INSTRUCTION
SAfETy INSTRUCTION
WARNING
Always remove the battery from your machine
for transporting, assemble or disassemble parts,
making adjustments and sharpening, cleaning or
when you do not use your tool. This will reduce the
risk of unintentional starting of the machine which
can cause serious injury.
–
Do recharge the battery of your machine with the
charger specified by the manufacturer. A charger
that is suitable for a certain type of battery can
cause a fire when used with another type.
–
The battery should not be crushed. If crushed, it
should not be heated or incinerated, Do not get it
short-circuited or disassembled, or immersed in
any liquid.
–
Only a specific type of battery can be used with a
cordless machine. Use of any other battery may
cause a fire.
–
When the battery is not in use, keep it away from
metal objects such as paper clips, coins, keys,
screws, nails or other objects that connect the
contacts between them. The short-circuit may
cause fire and / or explosion of it, and cause severe
burns and injury.
–
Avoid contact with fluid from a leaking battery
because of overheating or other factors. If this
happens, flush the affected area of the body with
water, and in case your eyes are affected, seek
medical attention immediately.
–
Due to the heat generated during charging, the
charger should not be used on a combustible
surface or in a flammable environment.
–
Never block the air slots of the charger.
–
Never disassemble the machine by yourself. An
incorrect reassembly can cause a risk of electric
shock or fire.
–
Unplug the charger when the machine is not in use
or when you are cleaning the machine.
–
Use only approved extension cords and in perfect
condition.
–
Make sure the ventilation of the place is enough
when charging. Poor ventilation of the charging
can cause a temperature of excessive use, causing
malfunction of the charger. The higher 40 ° C
should be avoided.
–
The charger cannot be put in closed cabinets or
near heat sources such as radiators or sunlight
because it will undergo increased heat which may
cause a fire or damage
–
the charger.
–
If you do not use the battery for a long time, remove
it from the charger and unplug it.
–
Do not attach anything on the charger with rivets or
screws. Rivets or screws may make ineffective on
the insulating housing. An adhesive label is better,
without blocking the ventilation slots.
–
Charge only original batteries.
–
If the power cord is damaged, make it replaced
by an authorized service center to avoid risk of
accidents.
To avoid the risk of damage and injury, make sure
the operating voltage of the charger, and never
attempt to recharge non-rechargeable batteries.
ASSEMbLy
Do not connect the battery before it is completely
assembled. Always use gloves when handling the
chain.
CHAIN AND CHAIN BAR ASSEMBLY
The chain MUST be so fitted over the guide bar that the
cutting edges of the cutters (a) face in the direction that
the chain runs (Usually forward)
10
WARNING
WARNING
Werbung
Inhaltsverzeichnis
