WARRIOR WEP8190CS Bedienungsanleitung Seite 14

SAfETy INSTRUCTION
The chain must be running at full speed before it makes
contact with the wood. Use the metal gripping teeth to
secure the saw onto the wood before starting to cut. Use
the gripping teeth as a leverage point "a" while cutting.
Do not operate the chain saw with arms fully extended
or attempt to saw areas which are difficult to reach, or
on a ladder. Never use the chain saw above shoulder
height.
SAW MAINTENANCE AND KICKBACK SAFETY
Follow maintenance instructions in this manual. Proper
cleaning of saw and chain and guide bar maintenance
can reduce chances of kickback. Inspect and maintain
saw after each use. This will increase the service life of
your saw.
Note: Even with proper sharpening, risk of kickback can
increase with each sharpening
MAINTENANCE AND STORAGE OF CHAIN SAW
– Remove the battery pack from chain saw, when not
in use
– Before moving from one place to another before
servicing
– Before changing accessories or attachments, such
as saw chain and guard
– Inspect chain saw before and after each use.
Check saw closely if guard or other part has been
damaged.
–
Check for any damage that may affect operator
safety or operation of saw. Check for alignment
or binding of moving parts. Check for broken or
damaged parts. Do not use chain saw if damage
affects safety or operation. Have damage repaired
by authorized service center.
– Maintain chain saw with care. Never expose saw
to rain.
– Keep chain sharp, clean, and lubricated for better
and safer performance.
–
Follow steps outlined in this manual to sharpen
chain.
–
Keep handles dry, clean, and free of oil and grease.
– Keep all screws and nuts tight.
–
When servicing, use only identical replacement
parts.
–
When not in use, always store chain saw in a high or
locked place, out of children's reach in a dry place
Replacing Saw Chain/chain bar
– Replace chain when cutters are too worn to sharpen
or when chain breaks.
– Only use replacement chain noted in this manual.
– Always include new drive sprocket when replacing
chain. This will maintain proper driving of chain.
– Inspect guide bar before sharpening chain. A worn
or damaged guide bar is unsafe. A worn or damaged
guide bar will damage chain. It will also make
cutting harder.
– Fit the tensioning catch into the new bar by
tightening the screw clockwise. The catch protrude
must be fitted into the bar hole.
SHARPENING SAW CHAIN
Remove battery pack from chain saw before
servicing. Severe injury or death could occur from
body contact with moving chain.
14
WARNING