Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TROUbLESHOOTING
TROUbLESHOOTING
PROBLEM
Motor fails to start when switch
trigger is depressed.
No lube for guide and chain
LED indicator of tool flashes for
1-19 times, motor fails to start
Slow cutting speed
The chain is too long
After the knob is loosened, the base
of the knob still cannot turn.
POSSIBLE CAUSE
Battery is not secure.
Battery is not charged.
Check that emergency brake is not
in working position
1.Check whether the tubing is
blocked.
2. Check whether there are
impurities in the oil tank blocking
the inlet pipe
Motor controller fault, or over
temperature, or low battery, or over
load, etc.
The chain is not sharp
Unadjusted tensioning components
Too much wood chips between knob
base and side cover.
18
SOLUTION
To secure the battery pack, make sure
the latches on the top of the battery
pack snap into place.
Charge the battery pack according
to the instructions included with your
model.
Push the emergency brake into working
position
1.Remove wood chips from the tubing.
2. Remove debris from the tank
1.
Release the trigger and restart
the machine after 3-5s; or
2. Stop the operation and cool the
tool and battery; or charge the
battery
3. Clean wood chips and debris
from air inlet and outlet regularly
Replace the chain
Adjust the tensioning components to fit
the chain length
Remove the two screws on the
side cover with the corresponding
screwdriver, clean up the wood chips
between the side cover and the knob
base, and install them back as is.
Werbung
Inhaltsverzeichnis
