WARRIOR WEP8190CS Bedienungsanleitung Seite 13

Filling oil tank:
1. Set chain saw on any suitable surface with oil filler
cap facing upward.
2. Clean area around the oil filler cap with cloth
unscrew cap.
3. Do not remove filter insert during filling.
4. Add chain saw oil until reservoir is full.
5. Avoid dirt or debris entering oil tank, refit oil filler
cap and tighten
CAUTION

To allow venting of the oil reservoir, small breather
channels are provided between the oil filler cap and
the strainer, to prevent leakage ensure machine is
left in a horizontal position uppermost when not in
use.
It is important to use only the recommended oil to
avoid damage to the chain saw. Never use recycled/
old oil. Use of a non approved oil will invalidate the
warranty.
OPERATION
CAUTION

Check the voltage and current supply: The voltage
and current supply must comply with the ratings on
the type plate.
Insert the battery pack, pull the hand guard, press the
Lock-off button on the rear handle, and then completely
press the On/Off switch to start the chain saw. Release
the Lock-off button during use, keep the On/Off switch
pressed, and release the On/Off switch when stopping.
Do not stop chain saw after sawing by activating the
front hand guard.
Lock-off button
On/Off Switch
Kickback Safety Devices on This Saw
This saw has a low-kickback chain and reduced
kickback chain bar. Both items reduce the chance of
kickback. Kickback can still occur with this saw.
The following steps will reduce the risk of kickback.
–
Use both hands to grip saw while saw is running.
Use firm grip. Thumbs and fingers must wrap
around saw handles.
– Keep all safety items in place on saw. Make sure
they work properly.
– Do not overreach or cut above shoulder height. •
Keep solid footing and balance at all times.
–
Stand slightly to left side of saw, this keeps your
body from being in direct Line with chain.
–
Do not let guide bar nose touch anything when
chain is moving.
–
Never try cutting through two logs at same time.
Only cut one log at a time.
– Do not bury guide bar nose or try plunge cut (boring
into wood using guide bar nose).
– Watch for shifting of wood or other forces that may
pinch chain.
– Use extreme caution when reentering a previous
cut.
– Use low-kickback chain and guide bar supplied with
this chain saw.
– Never use dull or loose chain. Keep chain sharp with
proper tension.
General behavior
Use the chain saw only with secure footing. Hold the
chain saw at the right-hand side of your body.
13
SAfETy INSTRUCTION
EN