Problem Identification And Solutions - SISTEMATICA Classic PHILO Benutzerhandbuch

PROBLEM POSSIBLE CAUSES
Power failure of the receiving group Verify that the power source is properly connected to the controller
Bad wiring connection
Incorrect installation of the receiver The receiver must not be shielded from ferrous masses (see "INSTALLATION" p. 83)
Emergency Button activated
The system does
not respond to
Incorrect replacement of
commands
the batteries of the handheld
System coding failure
Handheld batteries exhausted
Handheld batteries
almost exhausted
The system
Using the handheld beyond
responds to
the useful range
commands
intermittently
Connections to the battery and
to the utilities made with cables
of inadequate section or length
PROBLEM IDENTIFICATION AND SOLUTION
Check the wiring to the utilities (signals, solenoid valves etc.)
Check that the Emergency Button on the handheld (if present) is in the release position
Check the correct insertion of the batteries in the handheld; eventually replace them (see p. 75)
Recode the system (see p. 86)
Replace the batteries in the handheld (see p. 75)
Replace the batteries in the handheld (see p. 75)
Keep at a distance ≤ 100m from the controller
Check that the connections to the battery and to the utilities are made with cables
of adequate section or length
SOLUTION
93