Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SWITCHING ON THE SYSTEM
The system consists of a transmitter (handheld) and a receiver (Controller).
By pressing START on the handheld, the controller exits standby and
establishes the radio connection with the handheld (CloseLink).
The SYSTEM stops when the STOP key or the Emergency Button (if present)
are pressed down or after the TimeOut has elapsed, or when the radio
connection is lost (CloseLink), or if the Emergency Keypad on the receiver is
being used (if present).
INSTRUCTIONS
1. Power up the CONTROLLER paired with the handheld (see PAIRING p. 86 in
case of failure to pair) and wait a few seconds.
2. Press START on the handheld to enable the CONTROLLER to execute the
commands (START also activates the 'EMERGENCY' OUTPUT -EO-). If nothing
is pressed, the system will automatically go into standby after 2 minutes
(TimeOut), also deactivating the EO.
3. Press the desired key on the handheld to activate the output to command
80
(in our standard software the MASTER OUTPUT -MO- is combined with all
the function keys and activates simultaneously. Ex: KEY 1 => OUT 1 + MO).
4. Press STOP at the end of the activity to close the work session.
OPTIONS
PAGE CHANGE
The option multiplies the handheld keyboard by a maximum of 4 'pages'.
OPERATION
1. Power up the receiver paired with the handheld (see PAIRING p. 86 if the
system doesn't work) and wait a few seconds.
2. PAGE SELECTION: Simultaneously press START and key 1 on the handheld
to enable the functions on the first page; START + 2 for the second and
so on... up to 4 pages. We remind you that in the standard software the
EO is activated by pressing START, which automatically deactivates when
TimeOut expires or by pressing STOP.
3. COMMAND SELECTION: press the key on the handheld that activates the
function to be controlled. Example on page 1: press 1 = OUT 1 + MO is
activated (if the software is standard, the MO is activated in combination
with all the function keys).
4. Press STOP when done. To restore operation, press START + 1 or START +
2 again (up to 4 page changes) before choosing the command to activate.
By pressing the START button only, the system will not
manage any outputs. It is therefore always necessary to
select the page where you want to operate.
Werbung
Inhaltsverzeichnis
