Pairing - SISTEMATICA Classic PHILO Benutzerhandbuch

PAIRING

System coding (PAIRING) is necessary if you need to replace a receiver or
use it with a handheld device other than the one it was paired with when
purchased.
For most recent devices follow the ClassicLine AUTOMATIC PAIRING procedure:
1. As soon as the receiver is powered, within 5 seconds press down any 3
keys on the handheld at the same time (except STOP) until the YELLOW
LED flashes 3 times.
2. After this triple flash, the handheld/receiver system will be paired and
this PAIRING will remain valid until a new one is made. To verify, test the
commands of the system.
TUTORIAL PAIRING
Upon request, it is also possible to combine multiple handhelds
with the same controller.
QRCode
For older systems not updated to the latest version, follow the
MANUAL PAIRING procedure:
1. Remove power from the receiver.
2. Open it by unscrewing the two screws next to the connector (CNTR8 and
CNTR20) or the four screws on the bottom (CNTR32).
3. Locate and press the blue coding button on the electronic board.
4. Power the receiver and keep the blue button pressed for 3-4 sec .; the
green LED on the receiver board starts flashing, then release the button.
5. Simultaneously press any 3 keys on the handheld within 15 seconds of
switching on (until the green LED stops flashing).
6. At this point the handheld is coded with the receiver; verification is carried
out by testing the commands of the system.
7. Close the receiver by tightening the two screws (CNTR8 and CNTR20) or
the four screws (CNTR32) removed in step 2.
BLUE
CODING BUTTON
89