Emergency Button; Leds - SISTEMATICA Classic PHILO Benutzerhandbuch

EMERGENCY BUTTON

It is an option that helps ensure complete control of operations whenever an
emergency stop of the application is required.
1. By pressing the red button, the receiver turns off resetting all outputs.
2. To reactivate the system, release the button by turning it and then
press the START button.

LEDS

Among the various alerts, our LEDs are the most visual and immediate,
located in the upper part of the handheld.
GREEN LED
Indicates the presence of radio transmission and active CloseLink. It also
lights up when a function key is pressed when the activity is in progress
(if this does not happen, the batteries are probably flat or START was not
pressed before).
RED LED
This indicates that the batteries are almost empty and must be replaced.
Always check the correct insertion of the batteries according to the
polarity indicated inside the compartment.
YELLOW LED
In systems with SafetyPoint or Tilting Hand it indicates the 'out of range'
anomaly, in the PAGE CHANGE it flashes according to the selected page
number (1 time per page 1, etc) and when the PAIRING procedure ends it
flashes 3 times.
The handheld is also equipped with a twilight sensor (it is
not a LED, it does not light up) which detects the intensity
of light in the environment.
83