How To Manage: Error Codes - AEG BSE798280M Benutzerinformation

Problems with cleaning procedure
Description
There is too much water on
the bottom of the cavity after
cleaning.
Cleaning performance is not
satisfactory.
Power cut always stops cleaning. Repeat cleaning if it's interrupted by power failure.
Problems with Wi-Fi signal
Possible cause
Trouble with wireless network signal.
New router installed or router configuration
changed.
The wireless network signal is weak.
The wireless signal is disrupted by a micro‐
wave appliance placed near the oven.

8.2 How to manage: Error codes

When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Possible cause
You put too much detergent in
the oven before you started
cleaning.
You started cleaning when the
oven was too hot.
You did not remove all the ac‐
cessories from the oven be‐
fore cleaning.
Check your wireless network and router.
Restart the router.
To configure oven and mobile device again, re‐
fer to "Before first use" chapter, Wireless con‐
nection.
Move router as close to the oven as possible.
Turn off the microwave appliance.
TROUBLESHOOTING
Remedy
Next time evenly spread the
thin layer of a detergent on
the cavity walls.
Wait until the oven is cold. Re‐
peat cleaning.
Remove all the accessories
from the oven. Repeat clean‐
ing.
Remedy
39/96