Zanussi THE8301 Benutzerinformation Seite 18

Error code
E5A
E97
EH0
If the display shows other error codes, deactivate and activate the appliance. If the problem continues,
contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible solutions.
TROUBLESHOOTING
Problem
You cannot activate the appliance.
The programme does not start.
The appliance door does not close.
The appliance stops during operation.
The cycle time is too long or unsatisfactory dry-
1)
ing result.
18
Possible cause
Appliance motor overloaded.
Too much laundry or entrap in the
drum.
Internal fail. No communication be-
tween electronic elements of the ap-
pliance.
The mains supply is unstable.
The programme was not completed.
Remove the laundry from the drum,
set the programme and restart the cy-
cle.
The programme was not finished
properly or the appliance stoped too
early. Switch the appliance off and on
again.
If the error code appears again, con-
tact the Authorised Service Centre.
When the appliance is showing EH0,
please wait until main supply is stable
than press start. If the appliance
pause the cycle without any indication
then press the cycle start. If the warn-
ing will occur check the power cord /
socket integrity or main supply.
Possible solution
Make sure that the mains plug is connected to
the mains socket.
Check fuse in fuse box (domestic installation).
Press Start/Pause.
Make sure that the appliance door is closed.
Make sure that the installation of the filter is cor-
rect.
Make sure that the laundry is not caught be-
tween the appliance door and the rubber seal.
Make sure that the water container is empty.
Press Start/Pause to start the programme again.
Load is too small, increase the load or use the
Zeitprogramm (Time Drying programme.
Make sure that the weight of the laundry is suita-
ble for the duration of the programme.
Make sure that the filter is clean.
Remedy