Daily Use - Zanussi THE8301 Benutzerinformation

DAILY USE

START A PROGRAMME WITHOUT DELAY
START
1. Prepare the laundry and load the appliance.
CAUTION! Make sure that when
you close the door, the laundry
does not get caught between the
appliance door and the rubber
seal.
2. Press the on/off button to activate the
appliance.
3. Set the correct programme and options for the
type of load.
The display shows the programme duration.
Real drying time will depend on type of
the load (quantity and composition),
the room temperature and the humidity
of your laundry after spin drying phase.
4. Press the Start/Pause touch button.
The programme starts.
STARTING THE PROGRAMME WITH DELAY
START
1. Set the correct programme and options for the
type of load.
2. Press the delay start button again and again
until the display shows the delay time you want
to set.
You can delay the start of a
programme from a minimum of 1
hour to a maximum of 20 hours.
3. Press the Start/Pause touch button.
The display shows the countdown of the
delay start.
When the countdown is completed, the programme
starts.
CHANGE A PROGRAMME
1. Press the on/off button to deactivate appliance
2. Press the on/off button to activate the
appliance.
3. Set the programme.
Alternatively:
1. Rotate the selector knob to the
position.
2. Wait for 1 second. The display shows
.
3. Set the programme.
AT THE END OF THE PROGRAMME
When the programme is completed:
• An intermittent acoustic signal operates.
• The display shows
• The indicators
and Sieb (Filter) comes on.
• The Start/Pause indicator is on.
The appliance continues to operate with the anti-
crease phase for approximately 30 minutes or more
if Knitterschutz (Extra Anticrease) option was set
(see chapter Option - Knitterschutz (Extra
Anticrease) ).
The anti-crease phase reduces creasing.
You can remove the laundry before the anti-crease
phase is completed. We recommend, for better
results, that you remove the laundry when the
phase is almost completed or completed.
When the anti-crease phase is completed:
• The display still shows
• The indicators
and Sieb (Filter) comes on.
• Start/Pause indicator goes off.
1. Press the on/off button to deactivate the
appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying results:
• Inadequate default dryness level settings. See
chapter Adjustment of default dryness level
• Room temperature is too low or too high.
Optimal room temperature is between
18°-25°C.
Always clean the filter and empty
the water container when a
programme is completed.
"Reset"
Wärmetauscher (Condenser)
Wärmetauscher (Condenser)
13