Battery Charging - Würth ASS 18-1/2" COMPACT Originalbetriebsanleitung

Ambient storage temperature for the
tool and battery pack
Recommended ambient charging
temperature
Recommended battery type
Recommended charger
Know Your Product
See page 3.
1. LED light
2. Anvil
3. Trigger switch
4. Handle, insulated gripping surface
5. Control panel
6. Battery pack
7. Belt clip
8. Direction of rotation selector
9. Unlock button
Intended Use
The product is intended for driving in and loosening screws and bolts
as well as for tightening and loosening nuts within the respective range
of dimension.
The light of this power tool is intended to illuminate the power tool's
direct area of working operation and is not suitable for household
room illumination.
For damage caused by usage other than intended, the user is
responsible.
Symbols
Read all safety warnings and all instructions.
Warning
V Volts
Direct current
No-load speed
CE conformity
EurAsian Conformity Mark
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authority or retailer for recycling advice.
-15°C - +40°C
A battery that is new or has not been used for a longer period does
+5°C - +40°C
not develop its full capacity until after approx. 2 – 3 charging/
discharging cycles.
Do not place down the battery on radiators or expose it to intense
LI 18V/2 Ah BASIC
sunlight for longer periods; temperatures above 50 °C cause damage.
LI 18V/4 Ah BASIC
Keep the contacts/terminals of the charger and replaceable battery
LI 18V/5 Ah BASIC
clean. For optimal service life, fully charge the battery after use.
ALG 18/4 BASIC
ALG 18/6 FAST
NOTE: The battery supplied is partially charged. To ensure full
capacity of the battery, completely charge the battery in the battery
The lithium-ion battery can be charged at any time without reducing
its service life. Interrupting the charging process does not damage the
battery.
The lithium-ion battery is protected against deep discharging. When
protective circuit. The inserted tool stops.
Stop pressing the trigger switch after the product has been
Removing the Battery
To remove the battery, press and hold the unlocking button and pull
out the battery toward the front. Do not exert any force.
Observe the notes for disposal.
See page 4.
Remove the battery before any work on the product (e. g.,
maintenance, tool change) or during transport and storage.
Unintentional tool actuation can lead to injury.
draw the dust inside the housing and excessive accumulation of
metal particles may cause electrical hazards.
Inserting the tool
Slide the insert tool onto the anvil.
Removing the tool
Pull the insert tool from the anvil to remove.
When working with an application tool, check that the
application tool is connected securely on the anvil. When the
application tool is not securely connected with the anvil, it can
With this system, there will be a slight amount of play around the
application tool after connecting securely to the anvil. This has no
Only use special insert tool (e.g., special impact sockets) which were
constructed for the use with impact tools.
The anvil is driven by an electric motor via a gear and impact
mechanism.
The working procedure is divided into two phases:
Screwing in and tightening (impact mechanism in action).
The impact mechanism is activated when the screwed connection runs
tight and thus load is put on the motor. In this instance, the impact
Battery

Battery Charging

The battery can be damaged.
Changing the Tool
The motor's fan will
Method of Operation
16