TNi PRO INSTALLATION LOUDSPEAKERS
SUSPENSION
The TNi-WPRO cabinets come equipped with 7xM10 suspension points for installation and suspended use.
The suspension or 'flying' of cabinets should be performed only by properly qualified persons, in compliance with all local laws
and using approved hardware. Failure to do so could result in serious injury or death!
If you are not properly qualified or do not know of pertinent regulations, consult qualified personnel for advice and assistance.
For added safety, it is strongly recommended that the audio connections, mechanical fixing and mounting bracket are checked
periodically.
EYE BOLTS
The M10 eye bolts must be forged,
shouldered fittings and rated for the
purpose. A minimum thread length
of 30mm is mandatory.
Cast steel eye bolts of the type typically
available from DIY suppliers are NOT
suitable and should not be used under any
circumstances.
The suspension points are located on the
left, top, rear and base of the cabinet. Prior
to fitting, remove the M10x35 travel
bolts and store for future use.
© 2022 HH Electronics Ltd
3x M10 SUSPENSION POINTS
2x M10 SUSPENSION POINTS
1x M10 SUSPENSION POINT
1x M10 SUSPENSION POINT
Designed and Engineered in the UK by HH Electronics LTD.
For increased safety, the M10 safety harness
fixing point (or one of the flying point fixings)
should be used to make an additional
separately terminated fixing point (not shown
below).
30mm
EN
iNSTALL
INSTALLATION
8