Devolo MAGIC 1 LAN1-1 Handbuch Seite 71

ted by corresponding flashing behaviour regard-
less of this setting.
Powersaving
If Powersave mode has been enabled, the
devolo Magic 1 LAN switches to Powersave mode
automatically whenever reduced data transmissi-
on over ethernet is detected.
The latency (time for transmitting a data
packet) may be negatively affected.
Powersave mode is
devolo Magic 1 LAN factory default settings.
Standby
If
devolo Magic 1 LAN automatically switches to
Standby mode if no ethernet connection has been
enabled, i.e. if no network device (e.g. computer) is
switched on and connected to the network inter-
face and if Wi-Fi is disabled.
In this mode, the devolo Magic 1 LAN is not
accessible over the Powerline network. As soon as
the network device (e.g. computer) connected to
the network interface is switched on again, your
adapter can also be accessed over the electrical
wiring again.
disabled in the
Standby mode is
devolo Magic 1 LAN
Configuration 32
enabled, the
1-1