Devolo MAGIC 1 LAN1-1 Handbuch Seite 65

Powerline
Local device: Status information „connected" or
„not connected"
Network: Number of devices connected to the
network
Connections
The table lists all available and connected
devolo Magic adapters for your network along
with displaying the following details:
Device ID: number of the respective devolo Magic
adapter in the devolo Magic network
MAC address: MAC address of the respective
devolo Magic adapter
Transmit (Mbps): Data transmission rate
Receive (Mbps): Data reception rate
LAN—Ethernet
Port: network connection; if a connection has
been detected, the speed (10/100/1000 Mbps)
and the mode (half/full duplex) are specified;
otherwise, the status "unconnected" is
LAN – IPv4
DHCP: Display indicating whether DHCP is swit-
ched on or switched off
Address: IPv4 address in use to access the Internet
Netmask: The subnet mask used in a network se-
parates the IP address into a network address and
a device address.
Default gateway: Within the IP environment, this
function is usually provided by the router. All IP
packages which did not found any other routing
information are forwarded to the default gateway
Therefore, clients which do not support dynamic
routing send all IP packages to be routed to the de-
fault gateway.
Name server: address of the name server in use to
decode a name (e.g. www.devolo.global)
LAN – IPv6
Link-local address: selected by the device itself
and is valid for the "Link-locale Scope" range. The
address always begins with FE80. It is used to
establish connections within a local network
without the need for a global IP address.
Configuration 26
specified.
1-1
devolo Magic 1 LAN