Network Connection; Integrated Electrical Socket - Devolo MAGIC 1 LAN1-1 Handbuch

* Information about the web interface can be
found in Chapter 4 Configuration.
** Information on improving the transmission rate
can be found in Chapter 5.1 Bandwidth optimisa-
tion.
***A devolo Magic adapter switches to standby
mode after approximately 10 minutes if no active
network device (e.g. computer) is connected to the
network interface. In this mode, the devolo Magic
adapter cannot be accessed over the electrical wi-
ring. As soon as the network device (e.g. computer)
connected to the network interface is switched on
again, your devolo Magic adapter can also be ac-
cessed over the electrical wiring again.
Check whether the adapter is connected to
the mains supply correctly and whether the
pairing operation has been carried out suc-
cessfully. For more information about this,
refer to
3.4
devolo Magic 1 LAN.

2.3.2Network connection

You can use the network connection on the
devolo Magic adapter to connect it to a PC or tele-
vision using a standard network cable.

2.3.3 Integrated electrical socket

Always use the integrated electrical socket on the
devolo Magic adapter when connecting other
consumers to the mains supply. In particular,
electronic devices with mains adapter can negati-
vely affect PLC performance.
The integrated mains filter in the devolo Magic ad-
apter filters any such external interference and re-
duces any impairment of PLC performance.
Connecting the
Introduction 16
1-1
devolo Magic 1 LAN