Electrical Connection - Haier HWS42GDAU1 Bedienungsanleitung

Installation
24 h

8. Electrical connection

Before each connection check if:
▶ power supply, socket and fusing are appropriate to the rating plate.
▶ the power socket is earthed and no multi-plug or extension.
▶
Connect the plug to a properly installed household socket.
WARNING!
To avoid risks a damaged power cord must be replaced by the customer service (see
warranty card).
9. Door Reversibility
Before connecting the appliance to the power supply you should check, whether the door
swing must changed from right (as delivered) to left, if this is required by the installation
location and the usability
WARNING!
▶ The appliance is heavy. You need two persons to carry out the door reversibility.
▶
▶ Do not tilt the appliance more than 45 ° to prevent damage of the cooling system.
16
6. Fine tuning of the door
6
The appliance closes more easily if the levelling feet on
the front are used:
Rotate the adjustable feet (Fig. 6) to turn them up or
down:
Turning the feet clockwise raises the appliance.
▶
Turning the feet counterclockwise lower the appli-
▶
ance.
7. Waiting time
7
The maintenance-free lubrication oil is located in the
capsule of the compressor. This oil can get through
the closed pipe system during transport if the appli-
ance is tilted. Before connecting the appliance to the
power supply, wait 24 hours (Fig. 7) so that the oil runs
back into the capsule.
EN