Inhaltsverzeichnis
Werbung
6.3.3 Electric start-up
Make sure that the electricity
supply is duly earthed and 昀椀tted
with an automatic circuit breaker.
1. Insert the plug (昀椀g. 13G) into a
230 V power supply socket.
2. Press the start button to start the engine.
3. Once the engine is running, remove
the plug from the socket.
6.3.4 Operation
To operate with the machine proceed as described
below:
• Using the speci昀椀c control, position the chute
and the de昀氀ector (昀椀g. 1.G).
• To increase the length of the snow jet, position
the de昀氀ector upwards.
• To decrease the length of the snow jet, position
the de昀氀ector downwards.
• Set the gear depending on the route and the
depth of snow.
• Press the auger control (昀椀g. 12.C) to activate
auger rotation.
• Press the forward control (昀椀g. 12.D) to activate
traction.
NOTE Always use full throttle when using the
machine.
6.3.5 Steering
Steering helps drive the machine in the desired
direction.
Steering is facilitated on models with the "di昀昀-lock
release" (see technical data table).
6.3.6 Gear change
Gears are changed with the machine stopped.
To change gear, proceed as follows:
• Stop the machine by releasing the forward
control (昀椀g. 12.D) and the auger control
(昀椀g. 12.C).
• Move the gear stick to the desired position
(昀椀g. 12.A).
• Start operating as normal again.
IMPORTANT Changing
machine moving causes damage to the gearbox.
gears
with
the
EN - 9
6.4 STOPPING
To stop the machine, release the auger control
(昀椀g. 12.C) and the forward control (昀椀g. 12.D).
To turn o昀昀 the machine, proceed in one of the
ways described:
• Remove and turn the safety key (昀椀g. 13.A).
• Move the throttle (昀椀g. 13.C) to the stop position.
The fuel cock must always be closed
when the machine is not in use.
The engine may be very warm immediately
after it is shut o昀昀. Do not touch the exhaust or
adjacent parts. This can cause burn injuries.
IMPORTANT If you need to leave the machine
unattended, always remove the safety key (昀椀g.
13.A).
6.5 ADVICE FOR OPERATION
• Snow is removed more easily when it is still
fresh. Pass back over the already cleared
zones to remove snow residue.
• If possible, clear the snow in the direction of
the wind. Check the distance and the direction
of the removed snow jet.
• In strong winds, lower the de昀氀ector to direct
the discharged snow towards the ground,
reducing the likelihood of the wind transporting
the snow to the wrong areas.
• Once you have 昀椀nished work, leave the
machine running for a few minutes to prevent
ice from forming in the discharge chute.
• Always maintain a suitable speed for the snow
conditions, adjusting it so the snow is removed
in a constant 昀氀ow.
• Reduce the engine rotations before stopping it.
6.6 AFTER OPERATION
• Clean (par. 7.4).
• Move all the controls forward and back a few
times.
• Check the choke is engaged.
• Check there are no loose or damaged
components.
If
damaged components and tighten any screws
and loose bolts.
Do not cover the machine when the
engine and the exhaust are still warm.
necessary,
replace
the
Werbung
Inhaltsverzeichnis
