Inhaltsverzeichnis
Werbung
5.3 THROTTLE CONTROL
Regulates the engine's r.p.m.
The positions, indicated on the plate, correspond
to (昀椀g. 13.C):
1. Full throttle. Must always be used to
start the machine and during operation.
2. Minimum: used when the machine
is su昀케ciently warm during stationary
periods of operation.
3. Stop position (if present). The
machine stops immediately.
4. Intermediate position (if present).
Move the throttle lever towards the
hare/tortoise to increase/reduce the
speed and select the most suitable
speed for the operating conditions
(deep snow, uneven ground, etc.).
5.4 CHOKE CONTROL
Used to turn on the engine when cold. The choke
control has two positions (昀椀g. 13.D):
On the right - the choke is
engaged (to cold start)
On the left - the choke is not
engaged (normal warm start)
5.5 PRIMER
Press the primer bulb to inject fuel into the
carburettor intake manifold to facilitate start-up
when the engine is cold (昀椀g. 13.L).
5.6 HANDLE FOR MANUAL START
Enables manual starting of the engine (昀椀g. 13.H).
5.7 ELECTRIC STARTER
CONTROL (OPTIONAL)
Enables electric starting of the engine
(昀椀g. 14.M) when the machine is connected
to the electric mains using the speci昀椀c plug
(昀椀g. 13.G).
5.8 FORWARD CONTROL
Enables forward movement of the machine.
1. Lower the control (昀椀g. 12.D) until it reaches the
handle to advance.
2. Release the control to stop the machine's
forward motion.
If the forward control is activated with the
auger control, it remains inserted on release. It
disengages only when the auger control is also
released (昀椀g. 12.C).
5.9 AUGER CONTROL
Activates auger rotation.
• To activate auger rotation, lower the control
(昀椀g. 12.C) until it meets the handle.
• If the auger control is activated by itself, upon
release the auger stops rotating and the lever
automatically returns to its original position.
5.10
GEAR STICK
The machine is equipped with gears activated
using a stick (昀椀g. 12.A):
• 5 gears for adjusting forward speed
• 2 gears for adjusting reverse speed
5.11
POSITIONING
DEFLECTOR
Rotation of the discharge chute is adjusted using
the knob so that snow discharge can be aimed in
the required direction.
• Turn
the
anticlockwise to adjust the direction of the
chute.
De昀氀ector movement up and down is controlled
by the speci昀椀c lever (昀椀g. 12.B). Move the lever
forward/back to lower/lift the de昀氀ector.
• Lever fully forward = de昀氀ector lowered.
• Lever fully back = de昀氀ector high
5.12 HEADLAMPS SWITCH (OPTIONAL)
To turn the headlamps on, push the switch
(昀椀g. 12.F) forward.
• Headlamps on = red indicator light on
6. USING THE MACHINE
The safety regulations to follow during
machine use are described in chap. 2. Strictly
comply with these instructions to avoid
serious risks or hazards.
EN - 7
OF
CHUTE
knob
(昀椀g.
12.E)
AND
clockwise/
Werbung
Inhaltsverzeichnis
