Replacing The Rechargeable Battery; Charging; Maintenance And Cleaning - LIVARNO LUX 281134 Montage-, Bedienungs- Und Sicherheitshinweise

Replacing the
rechargeable battery
The batteries should be replaced every 12 months
to ensure optimum performance.
10346A/B:
Remove the lampshade
body .
3
Pull the solar cell housing
lampshade .
1
Switch off the light using the ON/OFF switch
by setting the switch to the „OFF" position.
7
Remove the fastening screws
cross-tip screwdriver. Then open the battery
cover on the solar cell housing
head screwdriver.
Replace the old battery
chargeable battery, taking care not to damage
the cables. Please note the polarity when in-
serting the battery. This is shown inside the bat-
tery compartment
batteries of the recommended type (see
„Technical Data").
Close the battery cover and tighten the retain-
ing screws using a small cross-tip screw-
8
driver. Set the ON/OFF switch
„ON" position.
Reattach the solar cell housing
shade . Then assemble the remaining parts
1
of the lamp.
10346C/D:
Remove the lampshade
body .
3
Turn the solar cell housing
lampshade counter-clockwise.
1
Switch off the light using the ON/OFF switch
by setting the switch to the „OFF" position.
7
Remove the fixing screws
cross-tip screwdriver.
Replace the old battery
chargeable battery, taking care not to damage
the cables. Please note the polarity when in-
serting the battery. This is shown inside the bat-
tery compartment
from the lamp
1
out of the
2
using a small
8
using a flat-
2
with a new re-
10
. Use only rechargeable
9
to the
7
to the lamp
2
from the lamp
1
out of the
2
using a small
8
with a new re-
10
. Use only rechargeable
9
batteries of the recommended type (see
„Technical Data").
Tighten the retaining screws
cross-tip screwdriver. Set the ON/OFF switch
to the „ON" position.
7
Reattach the solar cell housing
shade . Then assemble the remaining parts
1
of the lamp.
10346E/F:
Pull the solar cell housing
shade .
1
Switch off the light using the ON/OFF switch
by setting the switch to the „OFF" position.
7
Use a small cross-tip screwdriver to remove the
fastening screws
8
Replace the old battery
chargeable battery, taking care not to damage
the cables. Please note the polarity when in-
serting the battery. This is shown inside the bat-
tery compartment
batteries of the recommended type (see
„Technical Data").
Tighten the retaining screws
cross-tip screwdriver. Set the ON/OFF switch
to the „ON" position.
7
Reattach the solar cell housing
shade .
1

Charging

Please note, the solar garden light must be
switched on when the battery is charging. The
charging time via the solar cell varies by the inten-
sity of the sunlight and the incidence angle of light
onto the solar cell. Place the solar cell as perpen-
dicular as possible to incidence angle of light. This
will ensure the brightest light.

Maintenance and Cleaning

The LEDs cannot be replaced. The solar lamp is
maintenance-free, except for any necessary
change of battery.
with a small
8
to the lamp
2
off the lamp
2
.
with a new re-
10
. Use only rechargeable
9
with a small
8
to the lamp
2
GB 33