Start-Up; Assembling The Light; Installing The Light; Prior To Initial Use - LIVARNO LUX IAN 104775 Bedienungs- Und Sicherheitshinweise

Start-up

Start-up

Assembling the light

Remove the individual parts from the packaging
and assemble the solar light as shown in figures
A, D, E.
Unscrew the solar housing
wise from the lamp shade
Set the On/Off switch
to switch the lamp on.
Insert the solar housing
shade and tighten, turning clockwise.
2
Attach the lamp to the rod
Remove the ground stake
and insert the ground stake
with the tip pointing down (see Fig. D).

Installing the light

The solar light can be installed without a power
source. Only use the solar light with the included
ground stake . Push the assembled solar light far
4
enough into the ground (lawn, flower bed) so it is
stable.
Since the light relies on sunlight, consider and ob-
serve the following points prior to installation:
Select a location where the solar module
exposed to direct sunlight during the day.
Position the solar light so the solar module
is not covered or in the shade (trees, roof
ridge, etc.).
Be sure the solar module
by another light source, e.g. yard or street light-
ing, as this will prevent the light from switching
on at twilight. Remember many light sources
will only switch on due to the time or movement
during the night.

Prior to initial use

The solar light features a twilight sensor and an
On/Off switch. When fully charged the light on
time is approx. 6 to 8 hours.
8 GB
counter-clock-
1
(see Fig. A).
2
to the ON position
5
into the lamp
1
.
3
from the rod
4 3
into the rod
4 3
is
1
1
is not impacted
1
Unscrew the solar cell housing
clockwise from the lamp shade
Set the switch to ON.
5
Reattach the solar cell housing
shade . Then assemble the remaining parts
2
of the lamp (see Fig. D).

Light functions

Switch set to ON - the solar light will
5
automatically switch on at twilight. At dawn the
light will automatically switch off.
Switch set to OFF - the solar light is
5
permanently switched off.

Replacing the battery

The rechargeable battery is designed for pro-
longed operation. However, after a long time of
use if may need to be replaced. Rechargeable bat-
teries are subject to natural wear and the output
may decrease. For optimal performance the batter-
ies should be replaced every 12 months.
Replace the battery as shown in figures B, C, D.
Unscrew the solar cell housing
clockwise from the lamp shade
Switch the lamp off using the On/Off switch
by setting the switch to the „OFF" position.
Remove the fixing screws
cross-tip screwdriver. Then open the battery
cover on the solar cell housing
7
flat-head screwdriver (see Fig B).
Replace the old rechargeable battery
a new one. Be sure to insert the batteries in the
correct direction. It is indicated in the battery
compartment. Use only rechargeable batteries
of the recommended type (see „Technical
Data").
Set the ON/OFF switch
position.
Reattach the solar cell housing
shade . Then assemble the remaining parts
2
of the lamp (see Fig. D).
counter-
1
(see fig. A).
2
to the lamp
1
counter-
1
(see fig. A).
2
5
using a small
6
using a
1
with
8
to the „ON"
5
to the lamp
1