Storch 57 03 50 Originalbetriebsanleitung Seite 90

1. Rotate the clamping sleeve (1) in the direction of the arrow and hold.
2. Insert the saw blade (14) until the limit stop or remove it.
3. Let go of the clamping sleeve (1) (the clamping sleeve will rotate back
into its starting position).
4. Check that the saw blade is securely fitted.
Information for using jigsaw blades:
It is possible to use reciprocating or jigsaw blades. Reciprocating blades should
generally be used.
When inserting jigsaw blades, make sure that the jigsaw blade is inserted ver-
tically until the limit stop. Rotate the clamping sleeve (1) slowly back to its
starting position and make sure that the jigsaw blade sits in the recess.
Note: If a saw blade is broken at any point and it is not possible to remove it
from the saw blade tensioning appliance by hand:
Rotate the clamping sleeve (1) in the direction of the arrow and hold. Hook the
tip of a saw blade onto the broken off part and pull it out. A fine-tooth metal
saw blade is the most suitable.
Setting the limit stop
It is possible to limit the cutting depth by moving the limit stop (13) (e.g. when
sawing in front of a wall).
Move the limit stop (13) occasionally to make sure the saw blade wears evenly.
1. Press the button (12) and move the limit stop (13) to the desired
position.
2. Let go of the button (10) and move the limit stop until it clicks into
position.
Check that the limit stop (13) is securely fixed.
Translation of the original instruction 90