Performing Initial Setup - Sonoro RELAX SO-811 Bedienungsanleitung

3.5

Performing initial setup

When RELAX is powered on for the first time, the "Language" (to be used in the
display) selection shows on the display. Then, the "Setup wizard" appears on the
display. Follow the instructions below to configure some initial settings.
1. When the "Setup Wizard" is displayed, press
(or rotate the navigation knob) to select "YES" and then press OK to start the
setup.
2. You are then prompted to select:
• Time format (12 or 24-hour),
• Source of time & date auto update (Update from Radio, Internet or no update).
Depending on the selection you have made, follow the instructions on the
display to further set up date and time, time zone, daylight saving or wireless
network. Rotate the navigation knob on RELAX or press the navigation buttons
on the remote control to make selections and then press OK to confirm (see
chapter "Using the menus").
If update from Internet is selected, a Wi-Fi connection must be established.
When entering the key of your wireless network, rotate the navigation knob
on RELAX or press the navigation buttons on the remote control to select a
character and then press OK to confirm. To delete the last entry, select [BKSP].
To cancel entering the key, select [CANCEL]. To confirm the entered key, select
[OK].
80
or on the remote control
© sonoro audio GmbH 2022