Inserting And Replacing The Battery In The Remote Control; Using The Antennas - Sonoro RELAX SO-811 Bedienungsanleitung

3.3

Inserting and replacing the battery in the remote control

1. Open the battery compartment cover on the back of the remote control by
turning it anticlockwise using a small coin.
2. Insert the supplied batteries (CR2032, 3 V) with the label (+) side up.
3. Close the battery compartment cover by turning the cover clockwise using
a small coin.
Do not block the infra-red sensor on the RELAX and the infra-red
transmitter on the remote control during use.
3.4

Using the antennas

1. Screw the rod antenna located on the back of RELAX to the FM/DAB antenna
connector.
2. If you are using the rod antenna, pull the rods of the antenna apart and align
the antenna so that you have the best possible reception.
For even better reception, connect RELAX to a suitable house antenna.
3. Lift Wi-Fi antenna upwards.
© sonoro audio GmbH 2022
GB
79