Setting; Calibration - Pce Instruments Pce-Tds 200 Serie Bedienungsanleitung

5.2.6 Data logger dialogue
The data logger dialogue can be opened in any screen via the REC key and shows the current
settings as well as the status of the data logger. When the dialogue is open, a recording can be
started or stopped at any time by pressing and holding OK. In addition, the data logger menu
opens when the dialogue is open and the MENU key is pressed.
5.3

Setting

5.3.1 Decimal separator
Either a dot or a comma can be selected as the decimal separator for measured values.
5.3.2 Date & time
The date and time can be set in this menu. In addition, the date and time format can be selected.
5.3.3 Display
In this tab, the display brightness can be adjusted between 50 and 100 %. In addition, an
automatic dimming function can be activated. After the set time, the display is dimmed to a lower
brightness to save power. Pressing any key resets the brightness to the originally set value.
5.3.4 Language
The following menu languages are available: English, German, French, Spanish, Italian, Dutch,
Portuguese, Turkish, Polish, Russian and Chinese.
5.3.5 Auto power off
This option can be used to activate an automatic power-off function for the device. The instrument
switches off when the auto power off mode is activated if no key has been pressed for a certain
period of time. You can select 1 minute, 5 minutes or 15 minutes. In addition, automatic power-
off can be completely deactivated.
5.3.6 Factory settings
With the help of this option, the device can be reset to the factory settings. A distinction is made
between the device settings and the pipe presets. These can be reset separately.
When resetting the device settings, the default values for the measurement parameters and the
remaining menu options are restored.
When resetting the pipe presets, all presets saved on the meter will be deleted.
5.4

Calibration

The Calibration menu allows you to set a scaling factor that can be determined by calibration.
Since a special measurement setup is required for calibration, this menu is protected by a code.
Please send the device to PCE Instruments for calibration. You will find our contact details at the
end of the manual.
© PCE Instruments
36