Inhaltsverzeichnis
Werbung
1. Important information
Please read this manual completely and attentively before using the product for the first time. Keep this manual. It is part
of the product.
1.1 Safety instructions
Caution:
Risk of injury!
Tools are required for installation.
Electrical hazard!
Never put the connecting wires into a power socket! Regularly examine the transformer for damage. In case of any
damage, do not use the transformer.
Make sure that the power supply is switched off when you mount the device and connect the cables!
Only use VDE/EN tested special model train transformers for the power supply!
The power sources must be protected to avoid the risk of burning cables.
1.2 Using the product for its correct purpose
This product is intended:
- For installation in model train layouts and dioramas.
- For connection to an authorized model train transformer (e. g. item 5200) or a digital command station.
- For operation in dry rooms only.
Using the product for any other purpose is not approved and is considered inappropriate. The manufacturer is not re-
sponsible for any damage resulting from the improper use of this product.
1.3 Checking the package contents
Check the contents of the package for completeness:
- Sound module with blue plug
- Mounting material (2 screws, 6 plugs)
- Manual
2. Introduction
Experience the model railway with all your senses: The stationary sound module provides the specific sounds to the
scenes in the animated world. Sound module is equipped with an integrated loudspeaker and a connection for an ex-
ternal loudspeaker.
3. Mounting
Fasten the module with the enclosed screws. To ensure an optimal sound reproduction of the module, please note the
following hints:
1. The loudspeaker is an integrated part of the module. The upper surface of the module must always be uncovered in
order to provide a good sound dispersion.
2. If possible, gear the sound module towards the spectator, so please avoid upside down mounting under the layout.
3. The sound module should be installed near the respective functional model on your layout. You can also install the
module on the layout, e. g. in a building. This way you can even have a better sound and an optimal concordance be-
tween the visible and the audible sound source.
4. Connection
Fitting cables: Due to the low current consumption, thin cables can be used which can easily be hidden. It is
recommended to use a cross section of 0.14 mm² (e. g. Viessmann items 6860 – 6869 or 68603 – 68693).
To operate the sound module, please observe the following cabling and operating instructions.
Hint: This sound module is perfectly suitable for operation with the H0 Chicken run, moving, item 1528 (fig. 4).
4.1 Playing Sound
To play the sound, connect the sound module acc. to fig. 2.
By means of the on-off switch (marked with the letter A, item 5550) you can turn the sound module on and off (fig. 2).
4
EN
Werbung
Inhaltsverzeichnis
