Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setting time and sound sensor sensitivity (default time is at 0:00)
Press the SET button and the hour digit "0" flashes. Press + or - to set the hours. PM
1.
indicator will be on to indicate afternoon time. There is no AM indicator.
Press the SET button and the minute digits "00" flash. Press + or - to set the minutes. Press
2.
and hold + or - will accelerate setting at high speed.
Press the SET button and the time digits change to "24Hr" and flash. Press + or - to select
3.
"24Hr" or "12Hr" time format. When 12Hr time format is selected," PM" LED appears.
Press the SET button and "LO" flashes, press + or - to select "OFF", "HI" or "LO" sensitivity
4.
of the sound sensor.
5.
Press the SET button to confirm and exit setting. The set time is displayed.
Note:
Press and hold + or - will accelerate the setting process.
The clock exits the set mode when no key is pressed for 10 seconds.
Using white light / mood light
At normal time display, face the clock up front at a distance of 1 meter. Clap your hands once to
turn on the white mood light. Clap again to turn on the color changing mood light. Clap once again
to stop the mood light at a particular color. Clap again to turn off the mood light.
Off -> white light -> mood light (changing color) -> mood light (fixed color) -> off
Selecting the "HI" sensitivity of the sound sensor in point 4 above will increase the distance to 2.5
to 3 meters but the clock will becomes very sensitive to sound and changes its color more
frequently.
To adjust the brightness of the display and white / mood light
Rotate the TIME brightness dial at the back side of the clock to set display brightness.
Rotate the MOOD LIGHT brightness dial at the back side of the clock to set mood light brightness.
Turn the selected dial upward for higher brightness or downward for lower brightness.
Trouble shooting
If your clock displays irrelevant time or does not function properly, which maybe caused by
electro-static discharge or other interference. Unplug the DC jack at the back of the unit, open the
battery cover and take out the batteries. Then re-plug the DC jack and reinstall batteries by
observing the correct +/- polarity. Your unit will be reset to default settings and you need to set it
again.
Specifications
Default settings:-
Time
Sound sensor sensitivity
Care of the product
1.
Place your unit on a stable surface, away from sources of direct sunlight or excessive heat or
moisture.
2.
Protect your furniture when placing your units on a natural wood and lacquered finish by
using a cloth or protective material between it and the furniture.
3.
Clean your unit with a soft cloth moistened only with mild soap and water. Stronger agents
such as Benzine, thinner or similar materials can damage the surface of the unit. Make sure
the unit is unplugged before cleaning.
0:00, 24HR format
LO
EN3
Werbung
