To Insert And Remove The Batteries; Battery Life - Petsafe PBC17-14779 Gebrauchsanweisung

To Insert and Remove the Batteries

Note: Do not install the batteries while the Indoor Bark
Control is turned on.
1. Holding the grooved edges, slide the Battery Tray out (A).
2. Install two (2), 3-Volt (CR2032) batteries positive (+) side
up (B).
3. Slide the Battery Tray back in place (C).
To Verify the Batteries are Inserted
Correctly
1. Slide the On/Off Switch to ( | ) ON (D).
2. The LED should flash green once and there will be an
audible beep. Then the LED will flash green once every 5
seconds (E).
3. If the LED does not flash, you may have inserted the
batteries backwards. Try taking them out and turning them
over, ensuring that the (+) side is up.
4. If the LED still does not flash, contact the Customer Care Centre.
Replacement batteries (3-Volt, CR2032) can be found at many retailers. Contact the
Customer Care Centre or visit our website at petsafe.com for a list of common retailers.
8 petsafe.com

Battery Life

B
Average battery life is 2 months, depending on how often your dog barks. However, due to
A
your dog's learning process, your first batteries may not last as long as replacement batteries.
To conserve battery life, turn unit off when not in use.
Function and Response Table
E
Function
Unit is on
C
D
Emitting ultrasonic tone
Low battery condition
Risk of explosion if battery is replaced by an incorrect type. Do not
short circuit, mix old and new batteries, dispose of in fire, or expose to
water. When batteries are stored or disposed, they must be protected
from shorting. Dispose of used batteries properly.
LED Response
Green LED flashes once, followed by an audible beep,
then the green LED will flash once every 5 seconds
Red LED on
Red LED flashes 3 times every 5 seconds
petsafe.com 9