Grommet Installation Through A Hole In The Desk - ONKRON GM25 Benutzerhandbuch

1.2. Grommet installation through a hole in the desk:

Step.3
Step.4
6
L
J
H
G
Step.1
Step.2
K
Step.5
Step 1. Install grommet bolt H in panel G, as
shown on the picture.
Step 2. Attach panel G to the base B using
screws J. Check the picture.
Step 3. Use hex- key L.
B
Step. 4 Remove the top layer of two rubber
pads K.
Step. 5 Reapply pads K over each screw.