Assembly Of The Mount - ONKRON GM25 Benutzerhandbuch

WARNING!
DO NOT remove cable tie from the arm if you are not holding two parts
together.
ATTENTION!
А

2. Assembly of the mount

Step 1 . Take off plastic panel
А2
Step.1
А1
А2
Step.2
8
Firmly hold two halves of the arm together and have
another person cut off the cable tie from around the
arm.
Slowly release the pressure on the arm and let it
gradually stretch to its full length.
A1 from the arm.
PINCH POINT HAZARD!
Do not put hands around or near the joint as shown.
Step 2. Lay the cable through the tube of the mount, as
shown on the picture.
Step 3. Connect two cables as shown on the picture.
Step 4. Insert the arm of the mount into the base and
tighten the screw, using hex-key L.
Step.3
L
Step.4