Assembly Of The Mount; Clamp Installation On A Desk Edge - ONKRON GM25 Benutzerhandbuch

ATTENTION!

1. Assembly of the mount:

1.1. Clamp installation on a desk edge:

Step. 1 Take the clamp C and remove the two 0.24"(6mm) screws.
Step. 2 Disassemble the clamp C into two parts (C1 and C2).
Step.1
C
L
Step. 3 Connect part C1 to the base of B
with screws J. Hex-key L is required.
Step.3
С1
4
Lay cables as shown (leſt) prior to clamp or grommet
installation
0.24"
(6 mm)
L
J
B
Step.2
С1
Step.5
Step. 4 Remove the top layer of two
rubber pads K.
Step. 5 Reapply pads K over each screw.
С2
K
Step.4