Installation With A Grommet Hole In The Desk - ONKRON G140 Benutzerhandbuch

b) Installation with a grommet hole in the desk:
• Firstly disassemble C-Clamp (B) as shown on the picture. Attach part (J) to
the tube (E) using one screw (H). Plastic cover (C) must be installed too. Put
the clamp screw (from disassembled part B) through part (I) and through the
hole in the desk, and then twist it in the tube (E), by spinning the knob.
• Acceptable hole diameter 0.4" – 0.78"(10-20 mm). Key (L) may be used. Make
sure it is securely fixed on the table.
ATTENTION:
L
min hole diameter = 0.4"(10 mm)
max hole diameter = 0.78"(20 mm)
E
C
J
I
ATTENTION:
H
min desktop thickness = 0.4"(10 mm)
max desktop thickness = 2.95"(75 mm)
L
5