elero PatioControl Montageanleitung Seite 82

Error/fault
The actuator moves in the
wrong direction.
Actuator moves only with the
S4 and S5 keys on the PC
board, not with the hand-held
transmitter.
The actuator starts for no
obvious reason and without
manual control.
38
Possible cause Inspection
The connection lines are Check the direction of
reversed. rotation with S4 and S5
(S4 = closes the pergola).
The actuator was teached-in Test the direction of
incorrecty. travel with the hand-held
transmitter.
After teach-in DIP switch S1
was not switched on again.
The incorrect channel was
selected on the hand-held
transmitter.
Light, wind or rain has Check flash sequence of the
triggered a movement. red LED on the control board.
An Astro scheduler has An Astro time is activated.
triggered.
A teached-in Sensero cannot The power supply to the
be reached by radio. Sensero is off.
There is no Sensero present,
but one was teached-in.
Solution
Reverse the two connection
wires on the terminal on the
PC board.
Delete the radio channel,
then teach-in again.
After teach-in DIP set both
switches at S1 to ON.
Set the correct radio channel.
Deactivate the Astro time on
the hand-held transmitter.
Restore the power supply.
Delete all transmitters from
the radio module for the
actuator and teach in the
hand-held transmitter again.