Symbols Used In The Manual - DAB CONTROL BOX Handbuch

EN – CONTROL BOX®
1 OVERVIEW:
This booklet describes the instructions for the use and maintenance of the CONTROL BOX® series control panels.
This booklet must be carefully conserved for future reference after reading.
Before installing and connecting the panel, read the following instructions carefully.
The Manufacturer declines all responsibility for accidents or damages caused by negligence or failure to observe
the instructions provided in this booklet. Installation must be performed in compliance with the directives issued by
the local authorities and the regulations in force as well as with rules of good workmanship and in relation to the
particular installation in question.
1.1

SYMBOLS USED IN THE MANUAL:

This symbol indicates a potential risk of electrical
2 GENERAL INFORMATION:
The CONTROL BOX® series control panels are produced per single phase rated loads up to a maximum of 20A
nominal (230V).
3 DESCRIPTION:
CONTROL BOX® in the standard version comes supplied with the following functions:
- Connection and disconnection directly in line (DOL);
- Overload protection.
3.1 OPERATIONS:
CONTROL BOX® has been designed to operate connected to submerged and surface electric pumps, but may be
used with any asynchronous electric motor.
The overload protection is done by a manual switch with the maximum operating current written on the CONTROL
BOX® cover.
4 HANDLING AND STORAGE:
Make sure that the unit has not undergone any damage during shipment and that is still in its original packaging
without penetration of water or humidity. Store the unit in a dry and aerated place.
5 INSTALLATION:
Check to make sure that the rating place data (power/size and voltage)are correct as ordered
and that they are compatible with the load/motor that the CONTROL BOX® must control.
Plug off the CONTROL BOX® control box in order to guarantee the maximum safety of the
operator that will have to work on it.
Before the CONTROL BOX® has to be installed a Short-circuit protection.
CONTROL BOX® should be installed, if possible, in the shade, as near as possible to the motor,
in an upright position and making sure that the cable clamps are in the bottom position.
The container is rated IP55, but protection is guaranteed only if installation is correct.
nature
This symbol indicates a subject of particular
importance