Herunterladen Inhalt Inhalt Diese Seite drucken

Water Connection - Bosch EasyAquatak 100 Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für EasyAquatak 100:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 3
10 | English
Explanation of symbols
General hazard safety alert.
Never direct the water jet at people, animals,
the machine or electric components.
Warning: High pressure jets can be dangerous
if subject to misuse.
According to the applicable regulations, the
appliance must never be used on the drinking
water network without a system separator.
Use a separator as per IEC 61770 Type BA.
Water flowing though a system separator is considered not
drinkable.
Safety Notes for pressure washer
Read all safety warnings and all instructions.
Failure to follow the safety warnings and in-
structions may result in electric shock, fire
and/or serious injury.
The warning and information signs attached to the unit
provide important information for safe operation.
Apart from the information in the operating instructions
comply with the general safety regulations and regulations
for the prevention of accidents.
Connecting to the mains
The voltage of the power source must correspond with
u
the data on the type plate of the product.
We recommend that this product is only connected into a
u
socket which is protected by a circuit-breaker that would
be actuated by a 30 mA residual current.
The circuit breaker of the power supply should
have ≥ 16 A with at least type C.
The installation of the electrical supply must be carried
u
out by a qualified electrician and must comply with IEC
60364-1.
If the connecting cable or the mains plug are damaged,
u
have the repair carried out by an authorised Bosch Ser-
vice Centre.
Plugs and sockets situated near the work site or outdoors
u
should be to class IP 55 of BS 5490 to provide adequate
protection against ingress of water, etc. and cable entries
require effective sealing. Rubber shrouds should be
provided over cable glands. Drip-proof (class IP X2 of BS
5490) plugs and sockets to BS 4343 are suitable for use
indoors where the plug is away from the water spray area
where the appliance is in use.
Remove the plug from socket whenever the machine is
u
left unattended for any period.
Never touch the mains plug with wet hands.
u
Do not pull plug while operating the device.
u
F 016 L81 745 | (23.11.2022)
Do not run over, crush or pull the power supply cord or
u
extension cord, otherwise it may be damaged. Protect the
cable from heat, oil and sharp edges.
Do not use the unit, if the power supply cord or important
u
parts, e. g. high-pressure hose, power gun or safety
devices are damaged.
Warning: Inadequate extension cables can be
dangerous. When using an extension cable, the
plug and socket must be of watertight con-
struction and suitable for outdoor use.
When using an extension cable, the extension cable must
have the following dimensions:
2
– Ø 2.5 mm
, max. length 25 m
Note: When using an extension cable, it must be earthed
u
in accordance with the applicable regulations and con-
nected to the earth cable of your power supply via the
plug.
The connections (plugs and sockets) should be kept dry
u
and off the ground.

Water connection

Comply with the regulations of your water supply com-
u
pany.
All connecting hoses must have properly sealed joints.
u
Make sure that the supply hose is at least 12.7 mm (1/2")
u
in diameter and is reinforced.
The appliance should never be used on the drinking water
u
supply without a back flow valve. Water which has passed
the back flow valve is regarded as undrinkable.
The high-pressure hose must not be damaged (danger of
u
bursting). A damaged high-pressure hose must be re-
placed immediately. Only use hoses and connections re-
commended by the manufacturer.
High-pressure hoses, fittings and couplings are important
u
for the safety of the appliance. Use only hoses, fittings
and couplings recommended by the manufacturer.
Only clean or filtered water should be used for intake.
u
Application
Before use, check that the machine and operating equip-
u
ment are in perfect condition and are safe to operate. Do
not use if it is not in perfect condition.
Do not direct the jet against yourself or others in order to
u
clean clothes or footwear.
Do not use solvent-containing liquids, undiluted acids,
u
acetone or solvents, including petrol, paint thinners,
heating oil. The sprayed vapours are highly flammable,
explosive and toxic.
The appropriate safety regulations must be observed
u
when using the unit in dangerous areas (e. g. petrol sta-
tions). It is forbidden to operate the unit in potentially ex-
plosive locations.
The unit must be placed on a solid base.
u
Take care if using the machine in a confined space ensur-
u
ing that there is adequate ventilation. Ensure that all
vehicles are switched off at all times whilst cleaning.
Bosch Power Tools

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis