Water Connection - Bosch EasyAquatak 100 Originalbetriebsanleitung

Do not pull plug while operating the
u
device.
Do not run over, crush or pull the
u
power supply cord or extension
cord, otherwise it may be damaged.
Protect the cable from heat, oil and
sharp edges.
Do not use the unit, if the power sup-
u
ply cord or important parts, e. g.
high-pressure hose, power gun or
safety devices are damaged.
Warning: Inadequate extension
u
cables can be dangerous.
If an extension cord is used, the plug
u
and socket must be of watertight
construction. The extension cord
must have a cross section in accord-
ance with the operating instructions
and be protected against splashed
water. The connection must not be in
water.
When replacing plugs on the power
u
supply cable or extension lead the
spray water guard and mechanical
stability must remain intact.

Water connection

Comply with the regulations of your
u
water supply company.
All connecting hoses must have
u
properly sealed joints.
Make sure that the supply hose is at
u
least 12.7 mm (1/2") in diameter
and is reinforced.
The appliance should never be used
u
on the drinking water supply without
a back flow valve. Water which has
Bosch Power Tools
passed the back flow valve is re-
garded as undrinkable.
The high-pressure hose must not be
u
damaged (danger of bursting). A
damaged high-pressure hose must
be replaced immediately. Only use
hoses and connections recommen-
ded by the manufacturer.
High-pressure hoses, fittings and
u
couplings are important for the
safety of the appliance. Use only
hoses, fittings and couplings recom-
mended by the manufacturer.
Only clean or filtered water should
u
be used for intake.
Application
Before use, check that the machine
u
and operating equipment are in per-
fect condition and are safe to oper-
ate. Do not use if it is not in perfect
condition.
Do not direct the jet against yourself
u
or others in order to clean clothes or
footwear.
Do not use solvent-containing li-
u
quids, undiluted acids, acetone or
solvents, including petrol, paint thin-
ners, heating oil. The sprayed va-
pours are highly flammable, explos-
ive and toxic.
The appropriate safety regulations
u
must be observed when using the
unit in dangerous areas (e. g. petrol
stations). It is forbidden to operate
the unit in potentially explosive loca-
tions.
English | 13
F 016 L94 123 | (27.01.2021)