Technical Data - S+S REGELTECHNIK AERASGARD FSLQ Bedienungs- Und Montageanleitung

G
AERASGARD FSLQ
®
Maintenance-free air-quality sensor AERASGARD
quality (0...100 % VOC). The measuring transducer converts the measured variables into a standard signal of 0 -10 V. The in-wall sensor is mounted
in high-quality panel switch programmes, ideally of the brands Gira, Berker, Merten, Jung, Siemens or Busch-Jaeger (using in-wall adapters) either
individually or in combination with light switches, socket outlets, etc.
The sensor is used in offices, hotels, convention centres, apartments, shops, etc. and is used for evaluating the indoor climate.
This enables energy-saving room ventilation on an as-needed basis, thereby reducing operating costs and improving well-being.
The air quality is detected by a VOC sensor (mixed gas sensor for volatile organic substances). This determines the pollutant loading of the room
air by contaminated gases such as cigarette smoke, body vapours, breathing air, solvent vapours, emissions, etc.

TECHNICAL DATA

Power supply:
Power consumption:
AIR QUALIT Y ( VOC )
Sensor:
Measuring range:
Measuring accuracy:
Service life:
Warm-up time:
Response time:
Output:
Mounting:
Electrical connection:
Ambient temperature:
Permitted humidity:
Medium:
Protection class:
IP rating:
Standards:
S W I T C H P R O G R A MME
Manufacturer:
Housing:
Type ⁄ WG01 Measuring range
VOC
FSLQ
FSLQ-U 0...100 %
Note: This unit must not be used as a safety-relevant device!
FSLQ with active output, automatic calibration, in the in-wall housing, for determining the air
®
24 V AC ⁄ DC (± 10 %)
typically < 2.0 VA ⁄ 24 V AC; typically < 1.0 W ⁄ 24 V DC
VOC sensor (metal oxide) with automatic calibration
(VOC = volatile organic compounds)
Detection of the gases is not selective
0...100 % air quality (with reference to the calibration gas)
typically ± 20 % final value (with reference to the calibration gas)
> 60 months (under normal load conditions)
approx. 1 hour
< 60 s
0 - 10 V (0 V = clean air, 10 V = polluted air)
(low to elevated room air pollution load)
in-wall flush box Ø 55 mm
max. 1.5 mm², via push-in terminals
Storage –20...+50 °C;
Operation 0...+50 °C
max. 95 % RH, non-condensing air
clean air and non-aggressive, non-combustible gases
III (according to EN 60 730)
IP 20 (according to EN 60 529)
CE-conformity, electromagnetic compatibility
according to EN 61 326, EMC Directive 2014 ⁄ 30 ⁄ EU
GIRA System 55
(other switch programmes, manufacturers, colours as well as prices available upon request)
plastic, the standard colour is pure glossy white (similar to RAL 9010)
(other colours are available upon request with colour variants
depending on the respective light switch programme)
Output
VOC
0 -10 V
7
Rev. Data - V20
Item No.
1501- 5120- 1000-162