Moun�Ng And Installa�On; Moun�Ng The Projector - Derksen PHOS 15 indoor Nutzung

4. Moun�ng and installa�on
• Your new LED projector must be securely installed before you start using it. The moun�ng plate offers you a wide range
of op�ons. Any stable, flat surface is suitable, regardless of its orienta�on.
• Ensure that the suppor�ng structure can handle this load. It must carry at least four �mes the expected load. Informa-
�on on how much your device weighs is provided in the technical specifica�ons.
• Select the fastening materials based on the load, the nature of the support material, and the fire and building regula-
�ons.
4.1. Moun�ng the projector
WARNING! Danger of electric shock!
An electric shock can cause serious injury or death.
▶ Only open the device once the mains supply has been switched off.
1. Ensure that the device is voltage-free.
2. Loosen and remove the three countersunk screws on
the side of the equipment stand.
3. Disconnect the moun�ng plate from the equipment
stand.
4. Carefully disconnect the protec�ve ground conductor,
which is a�ached to the moun�ng plate, from the ter-
minal.
(Note: This makes the corresponding connec�on terminal
accessible if you want to connect your own supply cable in-
stead of using the already installed power cord. Cf. 4.2. Con-
nec�ng your own power cord)
20 / 44
Moun�ng
Derksen Lich�echnik