Aligning The Projector Head - Derksen PHOS 15 indoor Nutzung

3. Unscrew the gobo holder.
4. Insert the gobo into the holder with the mo�f mirror-
inverted. The mirror side must face the light source.
(Make sure to only hold the gobo by the sides when in-
ser�ng it into the holder.)
5. Ensure that the gobo is placed flat in the holder.
6. Screw the gobo holder together. Carefully press
against the gobo so that it is firmly and securely posi-
�oned in the holder.
A. Mirror side: The coated side of the gobo. The mirror side
faces the light source.
B. Dark side: The dark side of the coa�ng can be seen
through the glass. The dark side faces the lens.
7. Insert the gobo holder into the projector head.
8. Fasten the knurled screw.

5.2. Aligning the projector head

1. Loosen the countersunk screw.
2. Tilt the projector head into the desired posi�on. (Note:
There is a mechanical stop to limit the projector head's
rota�on and prevent damage to the cable. Do not �lt
or rotate the projector head without previously loosen-
ing the countersunk screw.)
3. Fasten the countersunk screw.
PHOS 15 indoor
Se�ngs
23 / 44