Connec�Ng Your Own Power Cord - Derksen PHOS 15 indoor Nutzung

5. Use the four corner holes for fixed installa�on. Use the
two arc-shaped elongated holes to correct the align-
ment a�er moun�ng.
6. Connect the protec�ve ground conductor to the ter-
minal.
7. Use the three countersunk screws to a�ach the equip-
ment stand to the moun�ng plate.
4.2. Connec�ng your own power cord
WARNING! Danger of electric shock!
An electric shock can cause serious injury or death.
▶ Only allow a qualified electrician to carry out electrical connec�ons.
1. Remove the moun�ng plate.
2. Loosen the strain relief.
3. Remove the a�ached power cord.
4. Ensure the mains voltage matches the input voltage of
the projector as specified in the technical specifica-
tions (220 – 240 V AC, 50 / 60 Hz) and your supply
cable is connected to a protective conductor via the
corresponding contact on the terminal block.
5. Use either the bushing with strain relief or the centre
hole in the moun�ng plate to connect your own power
cable.
PHOS 15 indoor
Installa�on
21 / 44